Spring has arrived and it has quite possibly been six months since your classic car has been started. Hopefully before the snow hit last year you took proper steps to secure your vehicle to get it ready for its winter slumber. But even with proper preparation, there are important steps necessary to check your vehicle over before you turn the key for that first drive of the spring.

VISUAL INSPECTION

Start with a visual inspection of the entire vehicle.

Begin with the body, work your way around and get under the vehicle to look for leaks or any areas a critter may have nested. You can usually find nest particles that have dropped down on the floor or on top of engine. If you are lucky, no critters have nested. If they have, try to use a shop vac to suck out the debris instead of using your bare hands. Throughout the inspection you have probably noticed all of the dust and grime that has built up and you may feel inclined to wipe a few spots while you are overlooking the car. Stop right there. Do not do this until you can wash the car properly so as not to scratch or dull the finish.

UNDER THE HOOD

Before attaching the battery, test it and/or give it a charge. While it is charging you can check belts, hoses and wiring to make sure everything looks good. Pump the brake pedal a few times to make sure it has a good pedal and no leaks. Change your oil and filter; moisture has had time to gather and pool inside the block. The same can be said about all lubricants and fluids, but use your discretion; the longer the vehicle has been sitting the more crucial this becomes. Remove the spark plugs and check for moisture and measure the gap. While the plugs are out you may choose to add a small amount of oil to the cylinder walls to lessen damage on initial start. With oil in the motor, turn the vehicle over by hand to get the lubrication process started. Disconnect the "+" coil wire and attach the battery. I would recommend turning the key to the run position and inspect the cars wiring. Look, feel and smell for shorts. Once the wiring appears to be o.k. go ahead and crank the engine over and check your fluid levels again. With the plugs out it will turn easily and hopefully clear out any junk in the combustion chamber. Check your fuel lines, carburetor, clutch and shifter for proper movement and operation.

BRAKES AND SUSPENSION

With the weight of the wheels, wiggle the tires back and forth and up and down. This will make sure that the wheel bearings

• 1
• 2
• next page >>

---

Add your voice

Know something about Classic car care: Best practices after storage?
We want to hear your view. Write now!