by Jarn

Created on: June 02, 2008   Last Updated: June 03, 2008

"How To Make Your Own Duck Decoys"

If you're an experienced duck hunter you've probably bought and used thousands of dollars worth of equipment over the years. Camouflage clothing, duck blinds, shotguns, ammunition, and bird calls all add up pretty quickly. It's likely you've already got a duck decoy; many hunters have dozens they like to use because of the slightly different nuances in each decoy's coloring and design. Whether you've got a hundred or are just starting hunting duck and don't have one, you're sure to benefit from this guide on how to make your own duck decoy that's surprisingly simple, cheap, and effective.

Things You'll Need:
Aluminum Duck Mold
Two-part Urethane Foam
Cotton Swabs
Waterproof Gloves
Liquid Car Wax
Protective Glasses or Goggles
Plastic Container or Bucket
Wood Paint Stirring Stick
Whittling Knife
Assorted Paint Brushes
Assorted Paint Colors
3M Rocker Panel Spray
Flat Head Screwdriver
Long Screws or Nails
C Clamps

Making A Duck Decoy
Step 1:
Assemble all the necessary materials and put on the protective glasses and waterproof gloves.

Step 2:
Pour some of the liquid car wax into the interior of the aluminum mold; use the cotton swabs to get into every single nook and cranny. This will allow the foam to come free cleanly from the mold later.

Step 3:
Pour the two-part urethane foam into the bucket and mix it well with the stirring stick. The fumes from this chemical mixture can be noxious so be careful not to position yourself directly over the bucket. Also make sure to work only in a well ventilated area.

Step 4:
Press the sides of the mold together and secure it by locking several C clamps along spots where the aluminum lays flat together.

Step 5:
Pour the urethane mixture from the bucket into the open spouts in the mold. There should be several as these molds often have the head and keel of the duck located separately from the duck body. So there will likely be several spouts. Don't worry about overfilling the mold, pour as much as you can in. Let it sit for a minute, then shake and bump the mold a bit to get the air bubbles to rise up to the spouts and out of the mold.

Step 6:
Wait overnight to let the urethane dry completely, then remove the C clamps and pry apart the mold halves with the screwdriver. Use the screwdriver to pop out the foam pieces.

Step 7:
Use the whittling knife to shave off the extra bits of foam from the spouts in the mold. It's a very easily worked material and should only take a few strokes to smooth the edges of the foam pieces.

Step 8:
Fit

• 1
• 2
• Next Page >>